Aristo #6 Wye switch (or is it really a #3 Wye?)

Well, it took several years after Aristo advertised the #6 wye to get one. I had a funny thread on the Aristo forum: "why oh why no wye?". (OK so it was funny at the time)

Well, it arrived. It has a #3 frog. I do not think you can technically call this a #6 wye, because each diverging route is the same angle as a #6, but the frog angle is 3, or as measured (see pictures below) about a 2.66.

No matter, it's about the same curvature as a #6, and that's what you are looking for.

It has the same poorly plated frog as the #6 does, and the frog likewise appears to be made from pot metal.

It also has the same crappy microswitch as the #6 does, little throw, not waterproof, not adjustable.

It also has the "too deep" frog, but not sure it's got the same problems as the #6 because of the #2.6 frog in the wye, I will research more.

Here are 2 pictures of the prototype that was shown for about 2 years:

Here's a closeup of the prototype frog, not plated:

Here's the measurements that show this is a #2.66 frog:

Here's a production frog:

Below, I measure out 3 inches:

Below, at the 3 inch mark, I measure the spread of the rails:

The ratio of 3 to 1-1/8" works about to 2.66

Train-Li makes an insert to make the #6 frog flange-bearing, i.e. a shim so the flange of the wheel can ride on the bottom of the flangeways. I don't think this is the best solution for switches, but for Aristo switches there may be no other way to correct the poor frog geometry. This is definitely needed on the #6, but I'm not sure it is needed on the wye. Anyway, you CAN take the Train-Li insert and bend it to fit into the wye frog. It does not fit well, as evidenced by the pictures below, but it seems workable. I will report back.

Below are pictures, notice how the frog angle is much wider than the insert, and how the "tongue" does not match the frog at all.

Weather Underground PWS KCACARLS78